6.
Bind a LUN with the new disks using the management tool of your choice:
– To use SAM, see
– To use Array Manager 60, see
– To use STM, see
After binding a LUN, you must execute the insf -e command to install special
Note
device files on the LUN. This makes the LUN usable by the operating system.
7.
Mount the file system on the LUN and restore the data to the LUN.
8.
Disable WCE on the disk modules using the following command:
amutil -w <ArrayID>
See
"Disabling Disk Module Write Cache Enable (WCE)" on page 302
information.
"Binding a LUN" on page 267
"Binding a LUN" on page 289
"Binding a LUN" on page 314
for more
Adding Capacity to the Disk Array
257