Moving A Disk Enclosure From One Disk Array To Another - HP Surestore Disk Array 12h - And FC60 Advanced User's Manual

6. Open the cam latch (C
7. Align the disk insertion guide (F) with a slot guide (G) and insert the disk into the slot.
Typically, install disk modules on the left side of the enclosure and fillers on the right
Installing disks left to right allows you to insert the disk completely without
Note
releasing your grip on the handle.
8. Push the disk all the way into the chassis, letting the internal guides control the angle.
9. Lock the disk in place by pushing the latch toward the disk until it clicks.
10. Repeat steps 3–9 to install additional disks and fillers.
Every slot must contain either a disk or filler.
C
AUTION

Moving a Disk Enclosure from One Disk Array to Another

If you have more than one HP SureStore E Disk Array FC60, it is possible to move a disk
enclosure from one array to another to balance capacity. The steps involved in moving a
disk enclosure are the same for installing a new enclosure.
The following steps describe moving disk enclosures from one disk array to another.
1. If necessary, backup all data on the disks in the enclosures to be moved.
2. From the host, stop all I/O activity to the disks in the enclosures and unmount the file
systems from the disks.
3. Unbind all LUNs on the disks in the enclosures using the management tool of your
choice:
– To use SAM, see
– To use Array Manager 60, see
– To use STM, see
Installing the Disk Enclosures
168
Figure 60) by pulling the tab toward you.
"Unbinding a LUN" on page 271
"Calculating LUN Capacity" on page 292
"Unbinding a LUN" on page 315.