Disk Enclosure Modules; Disk Module Or Filler Module - HP Surestore Disk Array 12h - And FC60 Advanced User's Manual

Disk Enclosure Modules

This section describes the procedures for replacing the hot swappable modules in the disk
enclosure.

Disk Module or Filler Module

!
Hot Swappable Component!
This procedure describes how to add or replace disk modules and disk slot filler modules.
When adding or replacing disk filler modules use the same procedure, ignoring any steps or
information that applies to disk modules only.
- To prevent damage from static electricity, follow standard ESD
C
AUTION
procedures and avoid touching exposed circuitry.
- Do not remove a disk module or filler module until you have a
replacement. An empty slot will disrupt the cooling airflow within the
enclosure and may cause overheating.
- To avoid removing the wrong disk, it is recommended that you identify the
disk by flashing its amber Fault LED. Identifying a disk can be done using
the management software tools. Removing the wrong disk can cause data to
become unavailable if the disk is part of the same LUN as the failed disk.
- Never move disks from one array to another or within an array with power
on. Moving disks with power on may result in data loss. Always power down
the disk array before moving disks. Moving disk should not be confused with
replacing a failed disk, which can be done with power on.
Disk Enclosure Modules
386