Led Status Monitoring; Ems Hardware Event Monitoring (Hp-Ux Only) - HP Surestore Disk Array 12h - And FC60 Advanced User's Manual

modules. This provides a storage capacity range from 36 Gbytes to over 3 Tbytes of usable
storage.

LED Status Monitoring

Both the controller enclosure and disk enclosure monitor the status of their internal
components and operations. At least one LED is provided for each swappable module. If an
error is detected in any module, the error is displayed on the appropriate module's LED.
This allows failed modules to be quickly identified and replaced.

EMS Hardware Event Monitoring (HP-UX Only)

The Disk Array FC60 is fully supported by Hewlett-Packard's EMS Hardware Monitors,
which allow you to monitor all aspects of product operation and be alerted immediately if
any failure or other unusual event occurs. Hardware monitoring is available at no cost to
users running HP-UX 11.0 or 10.20.
Hardware monitoring provides a high level of protection against system hardware failure.
It provides an important tool for implementing a high-availability strategy for your system.
By using EMS Hardware Monitors, you can virtually eliminate undetected hardware
failures that could interrupt system operation or cause data loss.
The EMS Hardware Monitor software with the Disk Array FC60 monitor is distributed on
the HP-UX Support Plus CD-ROM release 9912 and later. Complete information on
installing and using hardware event monitoring is contained in the EMS Hardware
Monitors User's Guide (B6191-90011). A copy of this book can be accessed from the
Systems Hardware, Diagnostics, & Monitoring page of Hewlett-Packard's on-line
documentation web site at http://www.docs.hp.com/hpux/systems/
The minimum supported version of the Disk Array FC60 hardware monitor (fc60mon) is
A.01.04. To verify the version of the monitor installed, type:
what /usr/sbin/stm/uut/bin/tools/monitor/fc60mon
Product Description
22