Lcd Unit/Fl Inverter - Toshiba Tecra M5 Maintenance Manual

4.24 LCD unit/FL inverter

4.24 LCD unit/FL inverter
Removing the LCD unit/FL inverter
To remove the LCD unit/FL inverter, follow the steps below and refer to Figure 4-43 to 4-46.
1. Remove the keyboard holder. (Refer to Figure 4-12 on page 4-22.)
2. Remove the mask seals (2 points), mask rubbers (2 points) and following screws
securing the LCD mask.
• M2.5×6B
• M2×4B
M2×4B S-THIN HEAD
Mask rubber
LCD mask
Figure 4-43 Removing the mask seal, mask lubber and screw
3. Remove the LCD mask (stuck with a double-sided tape) while releasing the latches.
4. Peel the insulator on the connector of HV cable and disconnect the FL cable and HV
cable from the FL inverter.
TECRA M5 Maintenance Manual (960-542)
FLAT HEAD screw
S- THIN HEAD screw
Mask rubber
Mask seal
[CONFIDENTIAL]
4 Replacement Procedures
×2
×2
Mask seal
M2.5×6B FLAT HEAD
4-61