Toshiba Tecra M5 Maintenance Manual page 281

4.16 Video board
4. Remove the video board from the slot of the base assembly.
Installing the Video board
To install the video board, follow the steps below and refer to Figure 4-28 to 4-29.
1. Connect the video cable to the connector CN9610 on the video board.
2. Install the video board in the slot of the base assembly.
3. Connect the video cable to the connector CN9600 on the system board.
4. Install the video cable holder while hooking the latches.
TECRA M5 Maintenance Manual (960-542)
Figure 4-29 Removing the video board
[CONFIDENTIAL]
4 Replacement Procedures
Video board
4-45