Toshiba Tecra M5 Maintenance Manual page 252

4 Replacement Procedures
Installing the HDD
To install the HDD, follow the steps below and refer to Figure 4-5 to 4-7.
CAUTION: Do not hold the HDD by its top and bottom flat surfaces. It may damage the
HDD.
1. Seat the HDD in the HDD Holder and secure them with the following screws.
• M3×4S
CAUTION: Do not apply pressure to the center of the HDD pack. It may damage the
HDD pack. Hold the HDD pack by its corners.
2. Set the connector of the HDD cable upward and connect firmly the HDD assembly
to the connector. Lay the HDD assembly down in the slot.
3. Set the HDD cover and secure it with the screw (with an e-ring).
4-16
FLAT HEAD screw
[CONFIDENTIAL]
×4
TECRA M5 Maintenance Manual (960-542)
4.5 HDD