Toshiba Tecra M5 Maintenance Manual page 269

4.10 Display assembly
Installing the Display assembly
To install the display assembly, follow the steps below and refer to Figure 4-17 to 4-20.
1. Place the display assembly on the base assembly and secure the latches.
2. Connect the LCD cable to the connector CN5000 on the system board.
3. Connect the Bluetooth cable to the connector CN4400 on the system board.
4. Connect the finger print sensor cable to the connector CN9700 on the system board.
5. Connect the touch pad cable to the connector CN3201 on the system board.
6. Secure the display assembly with the following screws and stick the insulator in
place.
• M2.5×6B
7. Turn the PC face down and connect the Speaker cable to the connector CN6170 on
the sound board in the HDD slot.
8. Stick the black insulator on the slot.
9. Close the display and turn the computer face down. Secure the display assembly with
the following screws.
• M2.5×4B
• M2.5×6B
• M2.5×16B
• M2×4S
TECRA M5 Maintenance Manual (960-542)
FLAT HEAD screw
FLAT HEAD screw
FLAT HEAD screw
FLAT HEAD screw
S-THIN HEAD screw
[CONFIDENTIAL]
4 Replacement Procedures
×3
×1 ("4B" in the figure below)
×6 ("6" in the figure below)
×7 ("16" in the figure below)
×1 ("4S" in the figure below)
4-33