4 Replacement Procedures
4.16 Video board
Removing the Video board
To remove the video board, follow the steps below and refer to Figure 4-28 to 4-29.
1. Remove the video cable holder while releasing latches. (one latch from the back)
2. Disconnect the video cable from the connector CN9600 on the system board.
video cable holder
Video cable
CN9600
3. Disconnect the video cable from the connector CN9610 on the video board.
4-44
Figure 4-28 Removing the video cable holder
[CONFIDENTIAL]
Latches
CN9610
TECRA M5 Maintenance Manual (960-542)
4.16 Video board