Toshiba Tecra M5 Maintenance Manual page 255

4.6 Slim select bay module
Installing the Slim select bay module
To install the slim select bay module, follow the steps below and refer to Figure 4-8 and 4-9.
1. Set the plastic frame on the side of the slim select bay module, and secure it with the
following screws.
• M2×3S
2. Set the connector and plastic brace and secure them with the following screws.
• M2×8S
3. Insert the slim select bay module firmly into the computer to connect it to the
connector on the system board.
4. Secure the latch with the screw removed from the screw hole. (The slim select bay is
latched.)
• M2.5×4B FLAT HEAD screw
TECRA M5 Maintenance Manual (960-542)
S-THIN HEAD screw
BIND screw
4 Replacement Procedures
×5
×2
×1
[CONFIDENTIAL] 4-19