Managing Stored Address Configurations; Address Configuration Library Dialog Box - HP StorageWorks 2/140 - Director Switch Product Manager Manual

Configuring the Director
2. Enter information into the appropriate fields.
3. Click the squares to either prohibit or allow connections. In
address 07 is prohibited from communicating with port address 05. Also, Port OC
is prohibited from communicating with all other port addresses.
4. Click Save As to open the Save Address Configuration As dialog box.
5. Click the Port Name field and enter a name.
Names must be between 1 and 8 characters in length. Valid characters are
uppercase A-Z, 0-9, hyphen (-), and underscore (_). The name may not be CON,
AUX, COMn (where n=1-9), LPTn (where n=1-9), NUL, or PRN.
Descriptions must be between 0 and 24 characters in length. Up to 24
alphanumeric characters allowed, including spaces, hyphens, and underscores.
6. Click OK to save changes and to close the Save Address Configuration As
dialog box.
7. In the Configure Addresses - "Active" dialog box, click Activate to activate the
configuration or click Cancel to close without activating.
NOTE: If you click Cancel after saving, your configuration will still be added to the library
without being activated.

Managing Stored Address Configurations

S/390 mode only. Once addresses configurations are created through the Configure
Addresses - "Active" dialog box they are saved to the Address Configuration
Library. Use this procedure to manage address configurations in the Address
Configuration Library.
To manage saved library entries:
1. Choose Addresses from the Configure menu on the menu bar, and then choose
Stored. The Address Configuration Library dialog box displays.
3–20
Figure 3–8, port
director product manager user guide