Configuring Switch Binding; Configuring Ports - HP StorageWorks 2/140 - Director Switch Product Manager Manual

Configuring Switch Binding

For complete procedures on configuring this optional feature, refer to
Binding" on

Configuring Ports

Use the procedures in this section to configure names, blocked and unblocked state,
10–100 km extended distance buffering, enable or disable link incident (LIN) alerts
for ports, port type, port speed, Port Binding, and the WWN binding name.
NOTE: The Configure Ports dialog box is different for S/390 and open systems mode. Those
options available in open systems mode only are labeled as such.
The Port Binding feature must be installed before the Port Binding and Bound
WWN columns can be used. Refer to
install the Port Binding feature.
Port configuration data is stored in NV-RAM on the switch. Configure data in the
following columns of the Configure Ports dialog box:
• Port #—You cannot edit this field. The physical port number, from 0-63 on the
Director 2/64, and 0-127 and 132-143 on the Director 2/140. Note that for the
Director 2/140, ports 128-131 are internal ports and not available for external
connections.
• Name (open systems mode only)—Enter a name for the port. The port names
display in the Port Properties dialog box and elsewhere in the Product Manager
to identify the port.
NOTE: To identify port numbers for which you want to provide names, place the cursor over
the ports in the Hardware View. As you move over a port, a message displays that
identifies the slot number where the port is installed.
To name ports in S/390 mode, use the Configure Addresses dialog box.
• Blocked (open systems mode only)—Placing a check mark in the check boxes of
this column blocks the operation of the port.
To block ports in S/390 mode, use the Configure Addresses dialog box.
• 10–100Km—This column is for extended distance buffering. You can enable
extended distance for a port even if it is not an extended distance port. However,
enabling extended distance buffering on a port disables the ability for the port to
send broadcast traffic. When you choose this option, the port can support up to 60
buffer-to-buffer credits (BB_Credits) to handle link distances up to 100 km. This
director product manager user guide
page 6–7.
"Configuring Feature
Configuring the Director
"Switch
Key" on page 3–24 to
3–9