HP StorageWorks 2/140 - Director Switch Product Manager Manual page 67

• Port card failure indicator—The blinking red and yellow diamond displayed on
the port card with the amber port card LED illuminated may indicate that the card
has failed. This may also indicate that an individual port has failed on the card. To
open the Port Card View, click the port card to examine individual port status. If
an individual port has not failed, the card is at fault.
Refer to
Card View. Refer to
symbol and indicator operation.
• CTP card failure indicator—The blinking red and yellow diamond ( ) on the
CTP card with the amber LED illuminated indicates that the card has failed.
• Active CTP card indicator—The green LED on a CTP card illuminates to
indicate that the card is active. Since the redundant CTP card on the left has failed,
this CTP card has become the active card. If both CTP cards are operational, no
LEDs illuminates on the backup card, while the green LED illuminates on the
active CTP card.
• Power, system error, and unit beaconing indicators—The green and amber
indicators on the far right of the front bezel simulate the power and system error
LEDs on the actual director bezel.
— Power Indicator—The green indicator simulates the power LED on the
actual director. When the indicator illuminates, the director is connected to
facility AC power and is operational. The indicator will be on if either power
supply is operating.
— System Error Indicator—The amber system error light indicator
(illuminated in
director. When this indicator illuminates, an event has occurred requiring
immediate attention, such as a system, fan, power supply, or port failure. View
details of system errors by choosing Event Log from the Logs menu on the
menu bar. The indicator in the Hardware View and the LED on the actual
unit remains illuminated until you right-click on the director graphic, away
from a FRU, and choose Clear System Error Light from the menu.
NOTE: If the amber LED flashes, this indicates that unit beaconing has been enabled
for the director. You can enable or disable unit beaconing when you right-click on the
director graphic, away from a FRU, and choose Enable Unit Beaconing from the
menu.
• Power supply failure indicator—When a blinking red and yellow diamond
displays on a power supply with the amber Fault indicator illuminated, the power
supply has failed. The backup power supply has taken over to supply DC voltage
to the director.
director product manager user guide
"Using the Port Card
Table 2–1
Figure 2–1) simulates the system error light on the actual
Monitoring and Managing the Director
View" on page 2–15
for details on port operating states and the status
for details on using the Port
2–7