HP StorageWorks 2/140 - Director Switch Product Manager Manual page 187

Table A–1: Product Manager Messages (Continued)
Message
Cannot set switch
date and time.
Cannot set switch
state.
Cannot set write
authorization
without defining a
community name.
Cannot start data
collection.
Cannot start
firmware install
while CTP
synchronization is
in progress.
director product manager user guide
Description
The switch date and
time cannot be set at
the Product Manager
application because
the Ethernet link is
down or busy.
The switch state
cannot be set at the
Product Manager
application because
the Ethernet link is
down or busy.
A community name
was not defined in the
Configure SNMP
dialog box for the
write authorization
selected.
The data collection
procedure cannot be
started by the
Product Manager
application because
the Ethernet link is
down or busy.
The director's CTP
cards are
synchronizing and
firmware cannot be
installed until
synchronization is
complete.
Information and Error Messages
Action
Retry the operation later. If
the condition persists, contact
the next level of support.
Retry the operation later. If
the condition persists, contact
the next level of support.
Provide a name in the name
field where write authorization
is checked.
Retry the operation later. If
the condition persists, contact
the next level of support.
Install the firmware after CTP
card synchronization
completes.
A–9