Switch Binding - HP StorageWorks 2/140 - Director Switch Product Manager Manual

Table A–1: Product Manager Messages (Continued)
Message
Are you sure you
want to send
firmware version?
Cannot change Port
Type while in S/390
mode without
SANtegrity feature.
Please contact your
sales
representative.
Cannot disable

Switch Binding

while Enterprise
Fabric Mode is
active and the
switch is Online.
Cannot disable
Insistent Domain ID
while Fabric
Binding is active.
Cannot enable
beaconing on a
failed FRU.
director product manager user guide
Description
This message
requests confirmation
to send a firmware
version from the
HAFM server's
firmware library to the
director. Firmware
library can store up to
8 firmware versions.
User attempted to
change a port type in
the Configure Ports
dialog box while in
S/390 mode, but the
optional SANtegrity
feature is not
installed.
User attempted to
disable switch
binding through the
Switch Binding
Change State dialog
box, but Enterprise
Fabric Mode is
enabled.
User attempted to
disable the Insistent
Domain ID
parameter through
the Configure
Switch Parameters
dialog box, but Fabric
Binding is enabled.
Occurs when
selecting Enable
Beaconing option for
a failed FRU.
Information and Error Messages
Action
Click Yes to send the
firmware version or No to
abort the operation.
Informational message.
Install SANtegrity before
changing port types in the
Configure Ports dialog box
while in S/390 operating
mode.
You must either disable
Enterprise Fabric Mode using
the Enterprise Fabric Mode
dialog box in the HAFM
application or set the switch
offline before you can disable
Switch Binding.
Disable Fabric Binding
through the Fabric Binding
dialog box before disabling
these parameters.
Replace FRU and enable
beaconing again or enable
beaconing on operating FRU.
A–3