Canon imageCLASS 2220 Copying Manual page 37

1
3
4
1-26 Selecting an Output Device (Select Output Device)
NOTE
•
It is impossible to select two different machines other than your own for cascade
copying. You must include your own machine as one of the output devices.
•
If Error Recovery for Cascade Copy is set to 'On', the remaining copy job is not
processed in the following cases:
- The machine is scanning originals for the Cascade Copy mode.
- The Cascade Copy mode is used in combination with the Cover/Sheet Insertion
mode.
- The Cascade Copy mode is used in combination with the Different Size Originals,
Auto Paper Selection, and Two-Sided modes.
- The normally operating printer has completed the cascade copy job.
- An error occurs in the normally operating printer.
- The cascade copy job has almost finished.
- The number of copies is less than six.
•
If Error Recovery for Cascade Copy is set to 'On', a machine in which an error
occurs cannot continue to print out the remaining pages of a copy job. Even if it
recovers, the remaining pages of a copy job are reassigned to another printer.
From the Copy Basic Features screen, select the copy
settings.
NOTE
•
When you use a remote copy printer, only those copy settings supported by the
selected remote copy printer are available.
•
When cascade copying, you cannot select copy settings that are not supported by
the remote copy printer. Also, if you select a remote copy printer equipped with a
different finisher, only the Collate and Group modes can be set.
Press (Start).
Copying starts.
NOTE
For instructions on how to cancel a remote copy or cascade copy job, see Chapter
2, "Checking Job and Device Status," in the Reference Guide.