Canon imageCLASS 2220 Copying Manual page 146

3
Press [–] or [+] to set the frame erase widths.
NOTE
•
If you want to enter values in millimeters, press [mm].
•
The default settings are '3/8" (10 mm)' for [Center], and '1/8" (4 mm)' for [Top],
[Left], [Right], [Bottom], and [Sides]. The maximum frame erase width is '1 15/16"
(50 mm)'.
•
If you enter a value outside the setting range, a message prompting you to enter an
appropriate value appears on the screen.
•
When entering values in millimeters, you can also use
(Clear) to clear your entries.
C
•
If you enter the value using
value by pressing [–] or [+].
G If you want to set the same width for all four borders:
❑
Press [Center] and [Sides] © press [–] or [+] to set their respective frame erase
widths © press [Next].
G If you want to set the top, left, center, right, and bottom widths
independently:
❑
Press [Adjust Each Dim.].
Erasing Shadows and Frame Lines from Copies (Frame Erase)
- (numeric keys), you can change the entered
9
0
- (numeric keys) and
9
0
2-35
2