Canon imageCLASS 2220 Copying Manual page 34

NOTE
•
You must select a remote copy printer that supports the selected copy settings. The
printers that do not support the selected settings are shown, but are grayed out.
Even if the remote copy printer supports the Copy mode, and if you select settings
other than Collate and Group, you can select only a remote copy printer equipped
with the same finisher as the original copy machine.
•
It is impossible to select two different machines other than your own for cascade
copying. You must include your own machine as one of the output devices.
•
If Error Recovery for Cascade Copy is set to 'On', the remaining copy job is not
processed in the following cases:
- The machine is scanning originals for the Cascade Copy mode.
- The Cascade Copy mode is used in combination with the Cover/Sheet Insertion
mode.
- The Cascade Copy mode is used in combination with the Different Size Originals,
Auto Paper Selection, and Two-Sided modes.
- The normally operating printer has completed the cascade copy job.
- An error occurs in the normally operating printer.
- The cascade copy job has almost finished.
- The number of copies is less than six.
•
If Error Recovery for Cascade Copy is set to 'On', a machine in which an error
occurs cannot continue to print out the remaining pages of a copy job. Even if it
recovers, the remaining pages of a copy job are reassigned to another printer.
3
Press (Start).
Copying starts.
NOTE
For instructions on how to cancel a remote copy or cascade copy job, see Chapter
2, "Checking Job and Device Status," in the Reference Guide.
Selecting an Output Device (Select Output Device)
1
1-23