Scan To E-Mail Error Codes - Kyocera FS-1128MFP Service Manual

(3) Scan to E-mail error codes

Code Display
1101 Error: Host name
1102 Error: User/Password
1104 Error: No Recipient address The destination address is not
1105 Error: Not support protocol
1106 Error: No Sender Info
2101 Error: Can not connect
2102 Error: Can not connect with
timeout
2103 Error: Response wait with
timeout
2201 Error: Network transfer
2202 Error: Network transfer with
timeout
2203 Error: Response wait with
timeout
2204 Error: E-Mail Size limit
3101 Error: Server response
3201 Error: Not Found Authenti-
cation Mechanism
9181 Error: Page max count over
Causes
SMTP sever name is not set.
Error SMTP server name.
User ID for the authentication
is not entered or entered
wrongly.
Wrong authentication pass-
word is entered.
specified.
SMTP Protocol is set to OFF.
Sender address is not enter
Select [Other authenticate]
when authenticating POP
before SMTP.
The specified server is not
SMTP server.
Network is not connected.
The server is unable to com-
municate.
The server is unable to com-
municate.
Error occurs on the network.
Error occurs on the network.
Response is not returned
from the server above speci-
fied time.
The size of E-mail exceeds its
limit.
The server is error status.
Server setting is not authenti-
cated normally.
Unsupported SMTP Authenti-
cation Mechanism is found.
The number of pages of a
send file exceeded 999
pages.
Remarks
Check procedures/corrective measures
Register [SMTP Server Name] in
[Advanced]-[SMTP] -[General] in
COMMAND CENTER.
Enter the correct user ID/password for
authentication at [Advance] in COMMAND
CENTER.
Enter the password of [Login User Name] of
the [POP3] page or the [SMTP] page cor-
rectly.
Specify the destination address.
Check ON [SMTP] in [Advanced]-[SMTP] -
[General] in COMMAND CENTER.
Enter the correct [Sender Address] in
[Advanced]-[SMTP] -[General] in
COMMAND CENTER.
Select valid POP3 user other than [Other].
Enter the correct [SMTP Server Name] in
[Advanced]-[SMTP] -[General] in
COMMAND CENTER.
Check if the server is operating properly.
Check the network connection (cable. net-
work condition within LAN, etc.).
Check if the server is operating properly.
Check if the server is operating properly.
Check the network connection (cable. net-
work condition within LAN, etc.).
Check the network connection (cable. net-
work condition within LAN, etc.).
Check the network connection (cable. net-
work condition within LAN, etc.).
Change the [E-mail Size Limit] in
[Advanced]-[SMTP] -[General]-[E-mail Set-
ting] in COMMAND CENTER.
Check if the server is working properly.
Check the settings for client/server authenti-
cation.
Check the settings for client/server Authenti-
cation Mechanism.
Set the number of pages as 999 or less.
2JN
1-4-33