Kyocera FS-1128MFP Service Manual page 61

Maintenance
item No.
Setting the fuser control temperature
U161
Description
Changes the fuser control temperature.
Purpose
Normally no change is necessary. However, can be used to prevent curling or creasing of paper, or solve a
fuser problem on thick paper.
Method
1. Press the start key.
2. Select the item to be set using the cursor up/down keys.
3. Change the setting using the cursor left/right keys or numeric keys.
Display
1ST TEMP T1
2ND TEMP T2
2ND TEMP T2-2
1ST FEED TEMP
2ND FEED TEMP
PRINT TEMP T3
PRINT TEMP T4
4. Press the start key. The value is set.
5. Turn the main power switch off and on.
Checking the fuser temperature
U199
Description
Displays the fuser temperature, the ambient temperature.
Purpose
To check the fuser temperature, the ambient temperature.
Method
1. Press the start key. The fuser temperature and ambient temperature are displayed in centigrade (
Display
HEAT TEMP
SURROUND TEMP
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Turning all LEDs on
U200
Description
Turns all the LEDs on the operation panel on.
Purpose
To check if all the LEDs on the operation panel light.
Method
1. Press the start key.
2. Select [EXECUTE] and press the start key.
All the LEDs on the operation panel light.
3. Press the stop key. The LEDs turns off.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Description
Description
Stabilized temperature during operation T1
Stabilized temperature under suspension T2
Stabilized temperature under suspension T2-2
Primary paper feed start temperature
Secondary paper feed start tempera
Temperature control during printing T3
Temperature control during printing T4
Description
Fuser temperature (
Ambient temperature (
Setting
range
-30 to 30
-30 to 30
-30 to 30
-30 to 30
-30 to 30
-30 to 30
-30 to 30
°
C)
°
C)
2JN-2
Initial
setting
0
0
0
0
0
0
0
°
C).
1-3-33