Kyocera FS-1128MFP Service Manual page 73

Maintenance
item No.
Adjusting the scanner automatically
U411
Description
Uses the adjustment original suppled with DP and automatically adjusts the following items in the scanner and
the DP scanning sections.
Purpose
To perform automatic adjustment of various items in the scanner and the DP scanning sections.
Method
1. Press the start key.
Display
ADJUST TABLE
ADJUST DP
Method: TABLE
1. Enter the target values which are shown on the specified original (P/N: 302FZ56990) executing mainte-
nance item U425.
2. Set a specified original (P/N: 302FZ56990) on the platen.
3. Enter maintenance item U411.
4. Select [ADJUST TABLE] using the cursor up/down keys.
5. Press the start key. Auto adjustment starts.
When automatic adjustment has normally completed, [OK] is displayed. If a problem occurs during auto
adjustment, [NG XX] (XX is replaced by an error code) is displayed and operation stops. Should this
happen, determine the details of the problem and either repeat the procedure from the beginning, or
adjust the remaining items manually by running the corresponding maintenance items.
6. To return to the screen for selecting an item, press the stop key.
Method: DP
1. Select [ADJUST DP] using the cursor up/down keys.
2. Set a specified original (P/N: 303LJ57010) in the DP.
3. Press the start key. Auto adjustment starts.
When automatic adjustment has normally completed, [OK] is displayed. If a problem occurs during auto
adjustment, [NG XX] (XX is replaced by an error code) is displayed and operation stops. Should this
happen, determine the details of the problem and either repeat the procedure from the beginning, or
adjust the remaining items manually by running the corresponding maintenance items.
4. To return to the screen for selecting an item, press the stop key.
Completion
Press the stop key. The screen for selecting a maintenance item is displayed.
Description
Description
Automatic adjustment in the scanner section:
Original size magnification, leading edge timing,
center line, input gamma, input gamma in mono-
chrome mode and matrix
Automatic adjustment in the DP scanning section:
Original size magnification, leading edge timing,
center line
2JN
Original to be used
for adjustment (P/N)
302FZ56990
303LJ57010
(Adjustment original
suppled with DP)
1-3-45