Kyocera FS-1128MFP Service Manual page 60

2JN-2
Maintenance
item No.
Setting toner loading operation
U144
Description
Sets toner loading operation after completion of copying. Toner is forcibly evacuated in case the average print-
ing ratio for the number of printed pages assigned by [PAGE] is lower than the ratio defined by [RATIO].
Purpose
To set whether or not toner is loaded on the drum after low density copying. Normally no change is necessary
from the initial setting.
Setting
1. Press the start key.
2. Select the item to be set using the cursor up/down keys.
3. Change the setting using the cursor left/right keys.
Display
T7 MODE
STEP1 PAGE
STEP2 PAGE
STEP3 PAGE
STEP1 RATE
STEP2 RATE
STEP3 RATE
4. Press the start key. The value is set.
5. Turn the main power switch off and on.
Checking the developing drive time
U157
Description
Displays the developing drive time for checking.
Purpose
To check the developing drive time after replacing the developing unit.
Method
1. Press the start key. The developing drive time is displayed in minutes.
Display
TIME(min)
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
1-3-32
Description
Description
Toner loading operation
Number of pages set (step1)
Number of pages set (step2)
Number of pages set (step3)
Printing ratio (step1)
Printing ratio (step2)
Printing ratio (step3)
Description
Developing drive time
Setting range Initial setting
1 (ON) / 0 (OFF) 1
0 to 50 3
0 to 50 8
0 to 50 20
0 to 100 1
0 to 100 2
0 to 100 3