Kyocera FS-1128MFP Service Manual page 62

2JN
Maintenance
item No.
Checking DP operation
U203
Description
Simulates the original conveying operation separately in the DP.
Purpose
To check the DP operation.
Method
1. Press the start key.
2. Place an original in the DP if running this simulation with paper.
3. Select the speed to be operated using the cursor up/down keys.
Display
NORMAL SPEED
HIGH SPEED
4. Press the start key.
5. Select the item to be operated using the cursor up/down keys.
Display
CCD ADP (NON P)
CCD ADP
CCD RADP (NON P)
CCD RADP
6. Press the start key. The operation starts.
7. To stop continuous operation, press the stop key.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Checking the operation panel keys
U207
Description
Checks operation of the operation panel keys.
Purpose
To check operation of all the keys and LEDs on the operation panel.
Method
1. Press the start key. and the screen for executing is displayed. [S01] is displayed
2. Starting with the system menu/counter key in the left most column, press the operation panel keys one
by one.
Each time a key is pressed, the count will increase and the corresponding LED (if any) will light up.
3. When all the keys on the operation panel have been pressed, [END] is displayed and all the LEDs light.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
1-3-34
Description
Description
Normal reading (600 dpi)
High-speed reading
Description
Without paper, single-sided original of CCD (continuous operation)
With paper, single-sided original of CCD
Without paper, double-sided original of CCD (continuous operation)
With paper, double-sided original of CCD
Figure 1-3-13