Enabling Option Rom Scan - Fujitsu PRIMERGY GX2570 M6 Upgrade And Maintenance Manual

▶ Choose the Recovery_L option from the update tool menu to start the BMC
update process.
CAUTION
If the process is interrupted, the BMC may be permanently corrupted.
▶
Do not interrupt the BMC upgrade process after it has started.
If the BMC does not work after flashing, disconnect the system from
the mains and reconnect it again.
▶ Shut down the server by pressing the power On/Off button.
▶ Disconnect the server from the mains to exit the BMC recovery state.
5.2.2

Enabling Option ROM scan

In order to configure an expansion card that has been installed or replaced, the
Option ROM of the card has to be enabled in the BIOS. The firmware of the
card is called by the BIOS upon reboot and can be entered and configured.
Option ROM can be enabled permanently (e.g. in case of a boot controller that
may require frequent setup) or temporarily for one-time configuration. When
permanently enabling the Option ROM of a controller in a legacy BIOS, keep in
mind that only two Option ROMs can be activated in the BIOS at a time.
▶ Enter the BIOS.
▶ From the Advanced menu select Option ROM Configuration.
▶ Identify the desired PCI slot and set its Launch Slot # OpROM setting to
Enabled.
▶ Save your changes and exit the BIOS.
Up to two Option ROMs can be activated in the BIOS at a time.
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
When the enabled expansion card is initialized during the POST phase of the
boot sequence, a key combination is displayed temporarily to enter the
firmware of the expansion card.
▶ Press the displayed key combination.
▶ Modify the expansion card firmware options as desired.
GX2570 M6 Upgrade and Maintenance Manual
Basic software procedures
71