Replacement of non-hot-plug components
8.2
Replacement of non-hot-plug components
When a defective non-hot-plug component is detected (for more information,
see chapter
"Starting up and operation" on page 55
Service (CSS)" manual on the ServerView Suite DVD 2), proceed as follows:
Ê Exit all applications and shut down the server properly (see section
"Switching the server on and off" on page
Ê Pull all power plugs out of the insulated sockets of the rack's internal power
supply.
Ê Remove the server from the rack (see section
in/from the rack" on page
8.2.1
Opening the server
You must remove the fan cover before removing the housing cover:
1
1
Figure 27: Opening the fan cover
Ê Push the two green buttons (1) in the direction of the arrow and lift the fan
cover up and off.
94
65).
39) and put the server on a table, for example.
Operating Manual
CSS components
and the "Customer Self
"Installing/removing the server
2
RX200 S5