Carrier 30XA080-500 Controls, Start-Up, Operation, Service And Troubleshooting Instructions page 37

Table 23 -- Space Temperature Reset Configuration
MODE KEYPAD ENTRY DISPLAY ITEM EXPANSION COMMENT
CONFIGURATION [] DISP
] UNIT
] SERV
] OPTN
] RSET Reset Cool and Heat Tmp
] CRST Cooling Reset Type
] 0 No Reset
] 0 No Reset Flashing to indicate Edit mode. May require Password
]/[] 4 Space Temp Use up or down arrows to change value to 4.
] 4 Accepts the change.
CRST
At mode level
SETPOINTS [] / [] Change to Setpoints Mode
] COOL Cooling Setpoints
] CSR1 Cooling Setpoint 1
] x 8 CRO2
] CRS1 Space T No Reset Temp Space Temperature where no temperature reset is
required.
] 0 Value of CRS1
] 0 Flashing to indicate Edit mode
] 72.0 Value of No Temperature Reset, 72 from the example.
] 72.0 Accepts the change.
CRS1
] CRS2 Space T Full Reset Temp Space Temperature where full temperature reset,
DGRC is required.
] 0 Value of CRS2.
] 0 Flashing to indicate Edit mode
] 68.0 Value of full Temperature Reset, 68 from the example.
] 68.0 Accepts the change.
CRS2
] DGRC Degrees Cool Reset Amount of temperature reset required.
] 0 Value of DGRC
] 0 Flashing to indicate Edit mode
] 6.0 Amount of Temperature Reset required, 6 from the
example.
] 6.0 Accepts the change.
DGRC
NOTE: Bold values indicate sub-mode level.
37