Carrier 30XA080-500 Controls, Start-Up, Operation, Service And Troubleshooting Instructions page 26

6. Press O to Parmneter P3900. Press O and use O
to change this value to 1. Press O to accept.
7. The &'ive will finish standard programming. Remove one
end of the jumper wire from terminal 8.
8. Press O again and go to Ptu'ameter P0003. Press O
and use O to change this value to 3. Press O to
accept.
9. Press O to Parmneter P1210. Press O and use O
to change this value to 6. Press O to accept.
10. Press O to Pmmneter PI310. Press O and use O
to change this value to 10%. Press O to accept.
11. Press the Function O key and then O" The display
will read 0.00 Hz.
12.
13.
Replace the wire jumper in terminal 8.
The &'ive is now active. Check fan rotation prior to testing.
If the fan is spinning forward, further adjustment is needed.
Fan should sit still when commanded speed is 0%. If the
fan is spinning forward slightly, press O and _ to
Pmameter P0761. Press am and use a to change flais
value to 0.1. Press Q to'q_accept. Check1"the fan. If rotation
has stopped no further adjustment is required. If the fan
is still rotating forward, press_ O and use O to change
this value to 0.2. Press O to accept. Repeat as needed
until the fan is holding still or is just bmely moving in
either direction. Do NOT enter a v_due
greater
than 0.5
for this
pm'ameter
without th.'st
contacting
your Cturier
representative.
Table 16 -- Low Ambient Temperature Controller Operator Panel
PANEL/BUTTON FUNCTION DESCRIPTION
Indicates Status The LCD displays the settings currently used by the converter.
Start Converter The Start Converter button is disabled by default. To enable this button set P0700 = 1.
O
O Stop Converter Press the Stop Converter button to cause the motor to come to a standstill at the selected
ramp down rate. Disabled by default, to enable set P0700 = 1.
Press the Stop Converter button twice (or hold) to cause the motor to coast to a standstill.
This function is always enabled.
O Change Direction Press the Change Direction button to change the direction of rotation of the motor.
Reverse is indicated by a minus (-) sign or a flashing decimal point. Disabled by default, to
enable set P0700 = 1.
O Jog Motor Press the Jog Motor button while the inverter has no output to cause the motor to start and
run at the preset jog frequency. The motor stops when the button is released. The Jog
Motor button is not enabled when the motor is running.
Functions The Functions button can be used to view additional information. Press and hold the but-
ton to display the following information starting from any parameter during operation:
1. DC link voltage (indicated by d - units V).
2. Output current. (A)
3. Output frequency (Hz)
4. Output voltage (indicated by o - units V).
5. The value selected in P0005 (If P0005 is set to show any of the above [3, 4, or 5] then
this will not be shown when toggling through the menu).
Press the Functions button repeatedly to toggle through displayed values.
Jump Function
Press of the Fn button from any parameter (rXXXX or PXXXX) to immediately jump to
r0000, when another parameter can be changed, if required. Return to r0000 and press
the Functions button again to return.
Allows access to the parameters.
Access Parameters O
Increase Value Press the Increase Value button to increase the displayed value. To change the Frequency
O Setpoint using the operator panel set P1000 = 1.
O Decrease Value Press the Decrease Value button to decrease the displayed value. To change the
Frequency Setpoint using the operating panel set P1000 = 1.
26