Carrier 30XA080-500 Controls, Start-Up, Operation, Service And Troubleshooting Instructions page 25

Fig. 12- Low Ambient Temperature Controller
Changing Single Digits in Parameter Values -- For chang-
ing the parametel_ value rapidly, the single digits of the display
can be changed by performing the following actions:
Ensure the operator panel is in the ptuameter v_due chang-
ing level as described in the Changing Parametel:s with the
Operator Panel section.
1. Press Q (function button), which causes the farthest
right digit to blink.
Change the value of this digit by pressing O or O "
2.
Pressing O (function button) again to cause
3. tile next
digit to blink.
4. Perforln steps 2 to 4 until tile required value is displayed.
5. Press O (parameter button) to exit the parmneter v_flue
changing level.
NOTE: The lunction button may also be used to acknowledge
a fault condition.
OuickCommissioning (P0010=I) -- It is important that
parameter P0010 is used for commissioning and P0003 is used
to select the number of parameters to be accessed. The P0010
parameter allows a group of parameters to be selected that will
enable quick commissioning. Parametel_ such as motor set-
tings and ramp settings are included. At the end of the quick
commissioning sequences, P3900 should be selected, which,
when set to 1, will carry out the necessary motor calculations
and clear all other parameters (not included in P0010=I to the
default settings. This will only occur in Quick Commissioning
mode. See Fig. 14.
Reset to FactoLy Default -- To reset all parameters to the fac-
tory default settings, the following parameters should be set as
follows:
1. Jumpers must be in place from termimds 2 and 4 and 5
and 8 (5 and 9 for 575v &'ives only).
2. Remove the keypad (pull out from top) and verify that
DIP switch 1 is OFF and 2 is ON. Replace keypad.
3. Power up the drive. Press Parameter t key. Press
to Parameter P0010.
4. Press Q, then O to change the 0 to a 1. Pless Q
again to accept the change.
5. Press _ to Parmneter P0311. Press _ and press
to change to 6-pole motors
this
value
1140 for
or 850 for units with 8-pole motors. Press _ to accept.
CHANGING P0004 -- PARAMETER FILTER FUNCTION
I StEP
II RESULT°N
DISPLAY
1 Press _ to access parameters
2 Press O until P0004 is displayed
Press O
value level
to access the parameter
4 Press _ or _ to the required
value
5 Press A to confirm and store the
value
6 Only the command parameters are
visible to the user.
CHANGING P0719 AN INDEXED PARAMETER
SELECTION OF COMMAND/SETPOINT SOURCE
I
I
STEP
Jl °" I
1 Press O to access parameters
2 Press 0 until P0719 is displayed
3 Press 0 to access the parameter
value level
Press 0 to display current set value
5 Press _ or _ to the required
value
6 Press A to conform and store the
value
7 Press 0 until rO000 is displayed
8 Press Q to return the display to the
standard drive display (as defined by
the customer)
Fig. 13- Changing Parameters
with the Operator Panel
25