Time Schedule Operation - Carrier 19XRV Start-Up, Operation And Maintenance Instructions Manual

For Discrete Poin_ -- Press _ or _ to se-
lect the desired state.
l START STOP RELEASE ENTER )
For Analog Poin_ -- Press IINCREASEI
[DECREASE] to select tile desiled value.
_, INCREASE DECREASE RELEASE ENTER )
or
3. Press _ to legister the new value.
INCREASE DECREASE RELEASE
ENTER
NOTE: When forcing or changing metric values, it is neces-
salT to hold down the sollkey for a few seconds in order to see
a value change, especially on kilopascal values.
To Remove a Force
I. On tile point status table press _ or IPREVIOUS]
to highlight the desired value.
l NE_ PREVIOUS S ELECT EX. )
2. Pless _ to access tile highlighted value.
NEXT PREVIOUS SELECT EXIT
D
3. Pless [RELEASE] to remove tile force and return tile
point to the PIC III's automatic control.
t INCREASE DECREASE RELEASE ENTER ,]
DD D
Force Indication -- A forced value is indicated by
"SUPVSR," "SERVC," or BEST fla. hmg next to the point
value on the STATUS table.
TIME SCHEDULE OPERATION (Fig. 19)
I. On tile Menu screen, press ]SCHEDULE].
STATUS SCHEDULE SETPOINT SERVICE
D
2. Pless _ or [PREVIOUS] to highlight tile desired
schedule.
OCCPC01S -- LOCAL Time Schedule
OCCPC02S -- ICE BUILD Time Schedule
OCCPC03S -- CCN Time Schedule
NEXT PREVIOUS SELECT
EXIT
Press _ to view the desired time schedule.
_, NEXT PREVIOUS SELECT EXIT .)
D
Press _ or IPREVIOUSI to highlight the desired
period or oveMde to change.
[, NEXT PREVIOUS SELECT EXIT .)
Press _ to access tile highlighted PERIOD or
OVERRIDE.
_, NEXT PREVIOUS SELECT EXIT .J
Press IINCREASE I or [DECREASE] to change tile
time values. OVERRIDE values are in one-hour
increments, up to 4 hours.
_ INCREASE DECREASE ENTER EXIT
.J
b. Press [ENABLE] to select days in the day-of-week
fields. Press IDISABLEI to eliminate days from the
period.
t ENABLE D,SA_LEENTER EXIT )
Fig. 19 -- Example of Time Schedule
Operation Screen
21