Override Operations; To View Or Change Time Schedule Operation - Carrier 17EX Start-Up, Operation And Maintenance Instructions Manual

3. Press SELECT to view the desired Point Status table.
4. On the Point Status
PREVIOUS until desired point is displayed on the screen.
For Discrete Points — Press START or STOP ,
YES or NO , ON or OFF , etc. to select the desired
state.
For Analog Points
DECREASE to select the desired value.
5. Press ENTER to register new value.

OVERRIDE OPERATIONS

NOTE: When overriding or changing metric values, it is nec-
essary to hold the softkey down for a few seconds in order
to see a value change, especially on kilopascal values.
To Remove an Override
1. On the Point Status
PREVIOUS to highlight the desired point.
2. Press SELECT to access the highlighted point.
3. Press RELEASE to remove the override and return the
point to the PIC's automatic control.
table press NEXT
— Press INCREASE
table press NEXT
Override Indication — An override value is indicated by
''SUPVSR,'' ''SERVC,'' or ''BEST'' flashing next to the point
value on the Status table.

TO VIEW OR CHANGE TIME SCHEDULE OPERATION

(Fig. 14)
or
1. On the Menu screen, press SCHEDULE .
2. Press NEXT or PREVIOUS to highlight one of the
following schedules.
OCCPC01S — LOCAL Time Schedule
OCCPC02S — ICE BUILD Time Schedule
OCCPC03-99S — CCN Time Schedule (Actual
or
3. Press SELECT to access and view the time schedule.
4. Press NEXT or PREVIOUS to highlight the de-
sired period or override that you wish to change.
5. Press SELECT to access the highlighted period or
override.
or
Fig. 14 — Example of Time Schedule
18
number is defined in CONFIG table.)
Operation Screen