Ethernet Controller Information; Enabling Features On Demand Ethernet And Demand Raid Software - Lenovo 3633 Installation And Service Manual

The USB flash device can be connected to the USB connectors on the system board. To locate the
connectors, see "System-board connectors" on page
multiple operating systems to run on a host system at the same time. The USB flash device is required to
activate the hypervisor.
To start using the embedded hypervisor, you must add the USB flash device to the startup sequence in the
Setup Utility.
To add the USB flash device to the startup sequence, do the following:
Step 1. Turn on the server.
Note: Approximately 5 seconds after the server is connected to power, the power-control button
becomes active.
Step 2. When the prompt
Step 3. From the Setup Utility main menu, select Boot Manager.
Select Add Boot Option; then, select Generic Boot Option ➙ Embedded Hypervisor. Press
Step 4.
Enter, and then press Esc.
Select Change Boot Order ➙ Change the order. Use the up and down arrow keys to select
Step 5.
Embedded Hypervisor and use the plus (+) and minus (-) keys to move Embedded Hypervisor in
the boot order. When Embedded Hypervisor is in the correct location in the boot order, press
Enter. Select Commit Changes and press Enter.
Step 6. Select Save Settings and then select Exit Setup.
If the embedded hypervisor flash device image becomes corrupt, you can download the image from
www-03.ibm.com/systems/x/os/vmware/esxi/
For additional information and instructions, see VMware vSphere documentation at
.
support/pubs/

Ethernet controller information

The Ethernet controllers are integrated on the system board. They provide an interface for connecting to a 10
Mbps, 100 Mbps, or 1 Gbps network and provide full-duplex (FDX) capability, which enables simultaneous
transmission and reception of data on the network. If the Ethernet connectors in the server support auto-
negotiation, the controllers detect the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T) and
duplex mode (full-duplex or half-duplex) of the network and automatically operate at that rate and mode.
You do not have to set any jumpers or configure the controllers. However, you must install a device driver to
enable the operating system to address the controllers.
To find device drivers, go to

Enabling Features on Demand Ethernet and Demand RAID software

You can activate the Features on Demand (FoD) software upgrade key for the following:
• Fibre Channel over Ethernet (FCoE)
• iSCSI storage protocol
• RAID
The FCoE and iSCSI storage protocols and RAID are integrated in the IMM2.1.
is displayed, press F1.
<F1> Setup
.
http://www.lenovo.com/support
21. Hypervisor is a type of software that enables
.
Chapter 4
http://
http://www.vmware.com/
.
Configuration information
37