Remote Console; Management Using Telnet - NETGEAR WNAP210 User Manual

Remote Console

Select Maintenance > Remote Management > Remote Console.
1.
Enter the following information in the Remote Console screen.
2.
Secure Shell (SSH). If set to Enable, the wireless access point allows remote access
•
only through Secure Shell and Secure Telnet. The default is Enable.
Telnet. If set to Enable, the wireless access point allows remote access through
•
Telnet. The default is Disable. If Telnet is enabled and the access point is accessed
using a browser, the Telnet access is disconnected.
Click Apply.
3.

Management Using Telnet

Open a secure Telnet session from your computer to the access point. The screen
1.
shown in the following figure should display.
Enter the login name and password (admin and password are the defaults).
2.
After successful login, the <Access Point Name> prompt should display. In this example,
the prompt is netgear334408.
Enter the desired CLI commands. You can enter
3.
The CLI commands are listed in
ProSafe Wireless-N Access Point WNAP210
Appendix B, Command Line
Management
34
to display the CLI command help.
help
Reference.