5. GUI Operations

GUI Operations
12. The DCS-200 GUI is now ready for use. Refer to the
drf=léÉê~íáçåë
The figure below illustrates a sample GUI screen:
Figure 5-4. DCS-200 GUI Setup Menu
Running the DCS-200 GUI is virtually identical to running the system from the physical front
panel. The similarities are:
The differences are:
106
on page 106 for important operating notes.
Note
If you have trouble establishing communications between
your PC and the DCS-200, in Chapter 6, refer to the
"Troubleshooting Ethernet
page 113 for instructions.
All control panel sections and menus are the same. In Chapter 4, refer to the
"Using the Menu
System" section on page 39 for details.
All input, transition, and "effect" selection methods are the same. In Chapter 4,
refer to the
"Using
Inputs" section on page 84 for details.
All buttons blink states are the same. In Chapter 4, refer to the
section on page 35 for details.
"Click" instead of press.
Use the Up/Down arrows in place of the ADJUST knob:
~
Click the Up Arrow to scroll up the menu tree.
~
Click the Down Arrow to scroll down the menu tree.
Click "Home" to return to the DCS-200 Home Page, if required.
All actions taken on the GUI are mirrored on the physical front panel, and
similarly, all actions taken on the front panel are mirrored on the GUI.
You can not enter or leave the Front Panel Lockout mode from the GUI.
"GUI
Operations" section
Communication" section on
"Button
States"
DCS-200 • User's Guide

   Also See for Barco DCS-200

   Related Manuals for Barco DCS-200

Comments to this Manuals

Symbols: 0
Latest comments: