Barco DCS-200 User Manual page 76

Hide thumbs Also See for DCS-200:
Table of Contents

Advertisement

4. Operation
Using the Setup Menu
pÉêá~ä=pÉíìé
From the System Menu, select Serial Setup to display the Serial Setup Menu, which
enables you to set system RS-232 parameters for the serial port.
SE RI AL S ET UP
> Bau d
Figure 4-46. Serial Setup Menu (sample)
The following functions are available:
76
In each case, system returns to the root menu.
When Ethernet setup is complete, you can communicate with the DCS-200 via the
Ethernet port.
~
In Appendix B, refer to the
for details on communicating with the DCS-200 via Telnet.
~
In Chapter 5, refer to the
page 104 for details on running the web-based GUI.
IP Address — The IP line is an information-only line that shows the current IP
address in all modes (with DHCP on or off). If an IP address has not been
established (no DHCP server found, or the network cable is not connected), the
address reads "000.000.000.000."
Note
The DCS-200's default IP address is 192.168.0.10
MAC Address — The M line is an information-only line that shows the MAC
(hardware) address of the unit's Ethernet port.
Par ameter s
Ha ndshaking
Re se t
Baud — Use this function to set the baud rate.
~
Adjustment
range: 9600, 38400, 57600 and 115200
~
Default: 115200
Parameters — This function is a combined setting of Parity, Data Bits and Stop
bits (in this order).
~
Adjustment
range: N81, E71, O71, E72, O72
~
Default: N81
Handshaking — This function controls the hardware flow of the serial port.
~
Adjustment
range: ON, OFF
~
Default: ON
When ON, RTS/CTS and DSR/DTR are used to control the data flow in and out of
the serial port. When OFF, the state of these control lines is ignored.
Reset — Use this function to reset all serial values to their default settings.
"Remote
Commands" section on page 134
"GUI Connection and
Launch" section on
1152 00
N 8 1
O N
DCS-200 • User's Guide

Advertisement

Table of Contents
loading

Table of Contents