Using Black; Black Auto Take Off; Black Auto Take On - Barco DCS-200 User Manual

Hide thumbs Also See for DCS-200:
Table of Contents

Advertisement

rëáåÖ=_ä~Åâ
The BLACK button is used to transition the system's output to/from black, no matter what
combination of sources are currently on Program. For example:
BLACK
When BLACK is pressed, one of two different actions can occur, depending on how the
"Black Auto Take" function is set in the User Preference Menu.
_ä~Åâ=^ìíç=q~âÉ=lÑÑ==
When the "Black Auto Take" function is
the TAKE button to transition to/from black.
Use the following steps to transition to/from black, when Black Auto Take is OFF:
1.
2.
DCS-200 • User's Guide
If a single source is on Program (e.g., Input 1), the system will mix to black at the
current transition rate.
If multiple sources are on Program (e.g., Input 1 + Key), the system will mix all
sources to Black at the current transition rate.

Black Auto Take Off

Black Auto Take On

Note
Refer to the
on setting parameters in the User Preference Menu.
Press BLACK. The button blinks to indicate that a transition to/from black is
pending.
Press TAKE. The system transitions to/from black, at the current transition rate.
Please note:
~
If the transition is "to" black, the BLACK button lights solid when black is
fully on Program.
~
If the transition is "from" black, the BLACK button automatically turns off
when the selected source is fully on Program.
Important
When the Black Auto Take function is OFF, if a source is
pending when TAKE is pressed, that source transitions to
Program after black is fully reached, and sources flip-flop in
the normal manner. If you do not want to transition to a new
source, simply press the blinking source to "un-pend" it.
"User
Preference" section on page 70 for details
OFF
in the User Preference Menu, you must use
4. Operation

Using Black

93

Advertisement

Table of Contents
loading

Table of Contents