2. Hardware Orientation
DCS-200 Rear Panel
3)
4)
5)
6)
7)
8)
26
HD/SD SDI Input
One BNC connector is provided for the SD-SDI or HD-SDI input.
Main Outputs
Two connectors are provided for the DCS-200's main program outputs. Both
outputs have the same resolution, and both can be used simultaneously.
~
One DVI-I connector is provided for the system's digital program output.
There are no analog outputs on this connector. In Appendix A, refer to
the
"DVI-I
Connector" section on page 119 for pinouts.
Note
The DVI-I connector allows you to use both DVI-D and DVI-I
cables as required.
~
One HD-15 connector is provided for the system's analog output. In
Appendix A, refer to the
page 118 for pinouts
Serial
One DB-9 connector is provided for Serial communications with the DCS-200
system. The port is also used for diagnostics or command-line operations.
Ethernet
One RJ-45 connector is provided for 10/100BaseT Ethernet communications with
the DCS-200 system. The port is used for running the built-in web-based GUI, for
diagnostics, or for command-line operations via Telnet (using port 23).
telnet 192.168.0.10 23
In Appendix A, refer to the
pinouts.
AC Power
One AC Connector is provided for connecting DCS-200 to AC. The integral
switch turns the chassis on and off. In Appendix A, refer to the
Electrical
Specifications" section on page 117 for power details.
Preview Outputs
Two outputs are provided for connecting to the Preview monitor: an HD-15
connector for analog monitors and a DVI connector for digital displays.
"Analog 15-pin D
Connector" section on
"Ethernet
Connector" section on page 120 for
"Physical and
DCS-200 • User's Guide

   Also See for Barco DCS-200

   Related Manuals for Barco DCS-200

Comments to this Manuals

Symbols: 0
Latest comments: