Flip-Flop Mode - Barco DCS-200 User Manual

Hide thumbs Also See for DCS-200:
Table of Contents

Advertisement

cäáéJÑäçé=jçÇÉ
Whenever you press TAKE to mix between inputs (including the LOGO), the DCS-200
automatically flip-flops inputs. Two actions occur when TAKE is pressed:
Figure 4-60. Flip-flop mode, before and after TAKE
Repeatedly pressing TAKE continues to flip-flop the current and pending sources in this
manner. Please note:
DCS-200 • User's Guide
For information about using the system in conjunction with HDCP inputs, refer to
the
"Using
HDCP" section on page 86.
The blinking "next" source transitions to Program. Once it is fully on Program, the
button lights solid.
The previous (solid) source on Program automatically becomes the pending
"next" source, and the button blinks.
Program
Pending
(solid)
(blinking)
1
2
3
4
Sources before TAKE
Pending
Program
(blinking)
(solid)
1
2
3
4
Sources after TAKE
If Black Auto Take is
OFF
TAKE to transition to black. If a source is pending, the source flip-flops to
Program — after the system is fully in black.
If Black Auto Take is ON, simply press BLACK to transition to black. If a source
is pending, it remains pending after the transition. There is no flip-flop.
If Key Auto Take is
OFF
to transition the key up or down. If a source is pending, you will transition to the
new source and add the key, and the new source flip-flops to Program.
If Key Auto Take is ON, simply press KEY to transition the key up or down. If a
source is pending, it remains pending after the transition. There is no flip-flop.
Inputs
5
6
7
Inputs
5
6
7
(in the User Preference Menu), you must press
(in the User Preference Menu), you must press TAKE
4. Operation
Using Inputs
8
SDI
LOGO
8
SDI
LOGO
85

Advertisement

Table of Contents
loading

Table of Contents