Barco DCS-200 User Manual page 77

Hide thumbs Also See for DCS-200:
Table of Contents

Advertisement

bafa=pÉíìé
From the System Menu, select EDID Setup to display the EDID Setup Menu, which
enables you to update the preferred EDID (Extended Display Identification Data)
resolution for the DCS-200.
E D I D S E T U P
> Inpu t
Figure 4-47. EDID Setup Menu (sample)
EDID is a VESA standard data format that contains information about a display device and
its capabilities, including the preferred (as well as the allowed) device resolutions.
The DCS-200's EDID file is stored in non-volatile memory. This file is read by a computer's
DVI graphics card during boot-up, when its DVI output is connected to a DVI-I input
connector on the DCS-200 system. The DCS-200 must be powered on first for the EDID
information to be read.
The following functions are available:
Figure 4-48. Programming EDID Message 1
DCS-200 • User's Guide
Type (7, 8 )
Important
This menu is designed for advanced users only. Do not
reprogram EDID unless it is necessary.
Input — selects the inputs that you wish to program: ALL, 1, 2, 3, 4, 5, 6, 7, or 8.
EDID Format — displays the current EDID format, and enables you to select a
new format to program into memory. Press SEL to program the preferred DVI
resolution, as defined on the EDID Format line.
Note
The DCS-200 can program the EDID EEPROM with the DVI
cable connected.
When SEL is pressed, the following message is briefly displayed.
P r o g r a m m i n g E D I D
P l e a s e w a i t . . .
7
1280x1024 @60
D i g i t a l
4. Operation
Using the Setup Menu
77

Advertisement

Table of Contents
loading

Table of Contents