Waste Ink Pad; P/S Assy - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390

4.5.4 Waste Ink Pad

Parts/Components need to be removed in advance
All exterior parts/ All control boards / Middle Housing / Printer Mechanism
Removal procedure
When removing the Waste Ink Pad, take extra care not to
contaminate the printer and surroundings with ink.
1. Remove the three Waste Ink Pads from the tray.
Figure 4-104. Removing the Waste Ink Pad
Insert the Waste Ink Pads into the trays inserting the slits of the
pads over the tabs
far as they will go (until their top surface locate lower than the top
surface of the tray edges).
Tab
Figure 4-105. Reinstalling the Waste Ink Pads
Disassembly/Assembly
Waste Ink Pad
on the trays. Make sure to push the pads as
Slit
Disassembly of the Printer Mechanism

4.5.5 P/S Assy

Parts/Components need to be removed in advance
All exterior parts/ All control boards / Middle Housing / Printer Mechanism
Removal procedure
Refer to the Orientation Definition below for the directions in the
following procedures.
"4.1.6 Orientation Definition (p.61)"
•
1. Release the connector cables from the six tabs, peel off the acetate tape and
remove the Ferrite Core from the cutout of the Lower Housing.
Lower Housing Connector Cable
Tab
Figure 4-106. Removing the Connector Cables of the P/S Assy
Revision B
Ferrite core
Tab
P/S Assy
Acetate Tape Position
94