Epson R260 - Stylus Photo Color Inkjet Printer Service Manual page 106

EPSON Stylus Photo R260/R265/R270, R360/R380/R390
Lubrication is required. See the page given below for the
lubrication information.
"6.1.3 Lubrication (p.131)"
Before attaching the right PG cam, remove the APG Unit and
install the cam matching its phase with the APG Unit.
(See Fig.4-91, Fig.4-
When attaching the spring (2) and the washer for the Right PG
Cam to the CR Shaft, make sure to attach them to the
positioning slits on the CR Shaft. (See Fig.4-146)
When installing the Timing Belt, make sure that it is not
twisted and the lumpy side comes to the inner side.
Up
Lumpy on both inner/
Figure 4-151. Reinstalling the Timing Belt
When installing the CR Unit, hook the Guide part to the Main
Frame.
Figure 4-152. Reinstalling the CR Unit
Whenever the CR Unit is removed or replaced, the required
adjustments must be carried out.
See "Table 5-4. Adjustment Items (p.116)" in Chapter 5
•
Disassembly/Assembly
92)
Lumpy side
(Inner side)
Flat side
(Outer side)
outer side
CR Unit
Guide Part
Disassembly of the Printer Mechanism
Remove the Cartridge Cover following the steps below. The Hinge,
Cover Cartridge need to be cut with a nipper or similar tool to be
removed. Therefore, whenever replacing the Cartridge Cover, the
Hinge, Cover Cartridge also must be replaced with a new one.
1. Cut the convex portion of the Hinge, Cover Cartridge with a
nipper or similar tool.
2. Disengage the hook from the opening made by the cut and remove
the Hinge, Cover Cartridge.
3. Remove the Cartridge Cover pulling out its two guide pins.
Right side view
: cut position
of the hinge
Convex
portion
Hook
Hinge, Cover
Cartridge
[Right rear of the CR Unit]
Figure 4-153. Removing the Cartridge Cover
Revision B
Cartridge Cover
: Guide Pin
Hook
Cut convex portion
of the hinge
107