Epson R260 - Stylus Photo Color Inkjet Printer Service Manual page 87

EPSON Stylus Photo R260/R265/R270, R360/R380/R390
2. Remove the six screws that secure the Printer Mechanism.
Screw : C.B.P. M3x8 (tightening torque: 7-9 kgf.cm)
•
(The numbers shown in the figure indicate the order of tightening the screws.)
[Left side]
5
2
Figure 4-86. Removing the Screws (Printer Mechanism)
3. Referring to ""Figure 4-82. Handling the Printer Mechanism
remove the Printer Mechanism from the Lower Housing.
When installing the Printer Mechanism, be extremely careful
not to let the cables at the left front side get caught under the
Printer Mechanism.
Tighten the screws in the order given in Fig.4-86.
Disassembly/Assembly
6
[Right side]
4
1
(p.87)"",
Removing the Printer Mechanism
Before installing the Printer Mechanism, make sure that the cables
are correctly routed referring to the figure below and the following
pages.
3
Figure 4-87. Routing the cables prior to Printer Mechanism
1. "Removing the Connector Cables of the P/S Assy" (p.94)
2. "Routing of the PF Motor cables" (p.103)
3. "Routing of the PF Motor cables" (p.103)
"Routing of the APG and PE Sensor Cables." (p.102)
Whenever the Printer Mechanism is replaced, the required
adjustments must be carried out.
• See "Table 5-4. Adjustment Items (p.116)" in Chapter 5
1
2
3
installation
Revision B
88