Epson R260 - Stylus Photo Color Inkjet Printer Service Manual page 100

EPSON Stylus Photo R260/R265/R270, R360/R380/R390
3. Disengage the connector cables of the PE Sensor and the APG Sensor from
the two hooks (A).
4. Remove the two screws and remove the Cable Holder Frame from the two
hooks (B).
• Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
: Hook A
: Hook B
Figure 4-128. Removing the Cable Holder Frame
5. Remove the left and right screws, and remove the Front Frame.
• Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
Removal Direction
1
Figure 4-129. Removing the Front Frame
Disassembly/Assembly
Cable Holder Frame
2
1
PE Sensor Cable
APG Sensor Cable
Front Frame
2
Disassembly of the Printer Mechanism
6. Remove the EJ Frame Assy.
Removal Direction
Figure 4-130. Removing the EJ Frame Assy
Lubrication is required. See the page given below for the
lubrication information.
"6.1.3 Lubrication (p.131)"
When installing the EJ Frame Assy, insert its two lower
bushings over the EJ Roller Shaft.
EJ Frame Assy
Bushing
Figure 4-131. Reinstalling the EJ Frame Assy
When installing the EJ Frame, make sure that the Left/Right EJ
Frame Springs are attached as shown in the figure below.
Carefully handle the EJ Frame as the springs come off easily.
Shorter
Left EJ Frame Spring
Figure 4-132. Reinstalling the Front Frame (1)
Revision B
EJ Frame Assy
Bushing
EJ Roller Shaft
Longer
Right EJ Frame Spring
101