Epson R260 - Stylus Photo Color Inkjet Printer Service Manual page 83

EPSON Stylus Photo R260/R265/R270, R360/R380/R390
5. Remove the screw and remove the Panel Board.
Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
•
• Positioning Hole: /Rib:
Figure 4-70. Removing the Panel Board (3)
6. Remove two screws and remove the LCD Panel and the Ground Plate LCD.
Screw : C.B.P. M2x6 (tightening torque: 2-3 kgf.cm)
•
LCD Panel
Figure 4-71. Removing the LCD Panel
7. Remove the SW Button (1) to (9) and the LED Light Guide Plate.
2 4
1
3
Figure 4-72. Removing the SW Buttons
Disassembly/Assembly
Panel Board
Ground Plate LCD
8
5 6 7
9
LED Light Guide Plate
Removing Control Boards
8. Peel off the double-sided tape and remove the two FFCs from the Shield Plate
PNL.
• Double-sided tape:
Shield Plate PNL FFC (1)
FFC (2)
Figure 4-73. Removing the FFC
Removing the Panel Board (for R260/R265/R270)
1. Remove the four screws and disengage the hook (
Board Assy.
• Screw : C.B.P. M3x8 (tightening torque: 7-9 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
1
Panel Board Assy
3
Figure 4-74. Removing the Shield Plate PNL (R260/R265/R270)
2. Disconnect the FFC from CN1 connector on the Panel Board.
3. Remove two screws and remove the Panel Board from the Shield Plate PNL.
Screw : C.B.S. M3x6 (tightening torque: 4-6 kgf.cm)
•
(The numbers shown in the figure indicate the order of tightening the screws.)
FFC
Shield Plate PNL
Figure 4-75. Removing the Panel Board (R260/R265/R270)
Revision B
) and remove the Panel
4
2
2
1
CN1
Panel Board
84