Epson R260 - Stylus Photo Color Inkjet Printer Service Manual page 133

EPSON Stylus Photo R260/R265/R270, R360/R380/R390
Contact point between
CR Unit and CR Shaft (1)
CR Shaft
Application Point
Figure 6-12. Lubrication of the CR Shaft (1)
Contact point between CR
Unit and CR Shaft (2)
CR Shaft
Application Point: Apply from the holes
Figure 6-13. Lubrication of the CR Shaft (2)
Maintenance
<Lubrication Points>
Contact point between CR Unit and the
CR Shaft
<Type>
G-71
<Application Amount>
210 ± 20mg x 2 points
<Application Timing>
Apply before installing the CR Unit
<Remarks>
Apply with Injector
After lubrication, move the CR Shaft
to left and right by 60mm while
rotating it, to spread the grease
evenly.
Make sure that the Timing Belt is
free from grease.
<Lubrication Points>
Lubrication holes of the Carriage Unit
<Type>
G-71
<Application Amount>
210 ± 20mg x 2 points
<Application Timing>
Apply before installing the CR Unit
<Remarks>
Apply with Injector
Apply grease from the two
lubrication holes.
Make sure that the Timing Belt is
free from grease.
Overview
LUBRICATION OF INK SYSTEM
Contact point between
Main Frame and I/S
Application Point
Figure 6-14. Lubrication of the I/S
LUBRICATION OF APG UNIT
Dowels on APF Unit
Dowel
Application
Point
Application Point
Figure 6-15. Lubrication of the APG Unit (1)
Revision B
<Lubrication Points>
On the Main Frame where the clutch
gear and spring of the Ink System
contact
<Type>
G-71
<Application Amount>
ø 1 x 1 circle
<Application Timing>
Apply before installing the Ink System
<Remarks>
Apply with Injector
<Lubrication Points>
Around the upper part of the dowels on
the APG Unit. (5 points)
<Type>
G-71
<Application Amount>
ø 1 x 1 circle x 5 points
<Application Timing>
Disassemble the APG Unit to apply the
grease before installing it.
<Remarks>
Apply with Injector
134