Panel Unit - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390

4.2.6 Panel Unit

Parts/Components need to be removed in advance
Paper Support / Printer Cover / Front Cover / Right Housing / Left Housing / USB
Housing / Upper Housing
Removal procedure
Take extra care to avoid injury from sharp metal edges. Before
starting, see the page given below to check the dangerous edges.
• "4.1.8 Sharp Metal Edges (Danger!)" (p.62)
1. Disconnect the two FFCs from CN3 and CN4 connectors on the Main Board.
(disconnect CN5 only for the R260/R265/R270)
R360/R380/R390
Main Board
R260/R265/R270
Main Board
Figure 4-23. Removing the Connectors (Panel Unit)
Disassembly/Assembly
Panel Unit
CN4
CN3
Panel Unit
CN5
Removing Exterior Parts/Components
2. Slide the Panel while pulling it upwards and disengage the two hooks. If the
hooks do not disengage, insert a flathead screw driver into the hole of the Front
Housing positioning rib from the backside of the panel, to disengage the two
hooks ( ).
3. Slide the Panel Unit upward to remove it.
Panel Unit
Slide, while pulling
upward and
disengage the hook
Removal Direction
Figure 4-24. Removing the Panel Unit
When reinstalling the Panel Unit, engage the four tabs by sliding
the unit downward, and insert the two ribs beside left and right
hooks into grooves until the hooks are securely engaged.
: Tab
: Hook
Mounting Direction
Slit
Figure 4-25. Reinstalling the Panel Unit
Revision B
[Backside]
Disengage the
hook
Screw Driver
Mounting Direction
Panel Unit
Rib
69