Ink System - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390
When installing the Stacker Assy, insert the tabs
Right Stacker Guides into the hole of the Lower Housing, and
secure the guides with the screws. Tighten the screws in the order
given in Fig.4-111.
Left Stacker Guide
Figure 4-114. Reinstalling the Stacker Assy
Disassembly/Assembly
of the Left/
Lower Housing
Right Stacker Guide
Disassembly of the Printer Mechanism

4.5.7 Ink System

Take extra care to avoid injury from sharp metal edges. Before
starting, see the page given below to check the dangerous edges.
• "4.1.8 Sharp Metal Edges (Danger!)" (p.62)
Take extra care not to spill ink and contaminate the
surroundings. Also, when removing the Waste Ink Tube, be
careful not to spill the ink.
Extra care must be taken to avoid injury from sharp edges of
the rib of the Main Frame.
Be careful not to drop and damage the shaft of the Carriage
Lock and the Torsion Spring, as they easily come off.
Pump Section
Figure 4-115. Ink System
Parts/Components need to be removed in advance
All exterior parts/ All control boards / Middle Housing / Printer Mechanism
Removal procedure
See the section given below on how to unlock the carriage.
• "4.1.7 How to Unlock the Carriage (p.62)"
Refer to the Orientation Definition below for the directions
indicated in the following procedures.
"4.1.6 Orientation Definition (p.61)"
•
Revision B
Torsion Spring
Shaft of the
Carriage Lock
97