Disassembling The Panel Unit - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390

4.3.5 Disassembling the Panel Unit

Panel Board removal
Be careful not to scratch or damage the exterior surface (coated or
decorative laminated parts) during disassembly and reassembly.
Since the R260/R265/R270 are not equipped with a LCD panel, the
removal procedure of the Panel Board differs from that of the
R360/R380/R390. The procedure for the R260/R265/R270 is given
on the page below.
• Removing the Panel Board (for R260/R265/R270) on page 84
Removing the Right/Left Laminated Panels (R360/R380/R390 only)
1. Disengage the four hooks on the rear side of the Panel Unit.
2. Push section of the Left Laminated Panel as indicated with the arrow to
disengage the tabs, and remove it.
3. Remove the Right Laminated Panel in the same manner.
Laminated Panel (L)
Figure 4-67. Removing the Left/Right Laminated Panels
Disassembly/Assembly
[Rear side]
: Hooks
[Front side] : Tabs
Laminated Panel (R)
Removing Control Boards
Removing the Panel Board (for R360/R380/R390)
1. Peel off the acetate tape.
2. Disengage the Ferrite Core from the hook.
Ferrite core
Acetate tape
Figure 4-68. Removing the Panel Board (1)
3. Disconnect the FFCs from CN1 connector on the Panel Board and CN1
connector on the LCD Board.
4. Remove the six screws, taking care not to damage the cables connecting the
two Panel Boards, remove the Shield Plate PNL in the direction of the arrow.
Screw : C.B.P. M3x10 (tightening torque: 5-7 kgf.cm)
•
: Positioning
section
Cables connecting the
two Panel Boards.
Removal Direction
CN1
Figure 4-69. Removing the Panel Board (2)
Revision B
Ferrite core
Hook
CN1
Shield Plate PNL
83