Asf Unit - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390

4.5.11 ASF Unit

Parts/Components need to be removed in advance
All exterior parts/ All control boards / Middle Housing / Printer Mechanism / Ink
System
Removal procedure
Refer to the Orientation Definition below for the directions
indicated in the following procedures.
"4.1.6 Orientation Definition (p.61)"
Removing the LD Roller Guide
1. Move the CR Unit to the left (the opposite side to the home position).
2. Remove the screw that secures the LD Roller Guide.
• Screw : C.B.S. (P4), M3x6 (tightening torque: 7-9 kgf.cm)
3. Push the tabs on the right and the left, slide the LD Roller Guide upward to
remove it disengaging the five hooks.
Hook
LD Roller Guide
Figure 4-139. Removing the LD Roller Guide (1)
Disassembly/Assembly
Hook
Tab
Removal Direction
Disassembly of the Printer Mechanism
4. Remove the Torsion Spring 137.7 from the LD Roller Guide.
Torsion Spring
LD Roller Guide
Figure 4-140. Removing the LD Roller Guide (2)
Removing the ASF Assy
5. Remove the two screws on the rear side.
• Screw : C.B.S.(P4), M3x6 (tightening torque: 7-9 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
[Rear side]
1
ASF Unit
Figure 4-141. Removing the Screws (ASF Unit)
6. Remove the hooks (1), (2) and the tip of the Change Lever that secure the
ASF Unit from the Main Frame.
Change Lever
Figure 4-142. Disengaging the Hooks (ASF Unit)
Revision B
2
Hook (1)
Hook (2)
104