Removing The Card Board (R360/R380/R390 Only) - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual

EPSON Stylus Photo R260/R265/R270, R360/R380/R390

4.3.4 Removing the Card Board (R360/R380/R390 only)

Parts/Components need to be removed in advance
All exterior parts/components / Main Board Unit
Card Board Removal
R360/R380/R390 are equipped with a Card Board. Remove the
Card Board after removing the Main Board. Refer to
R270 & R360/R380/R390 Disassembly
1. Remove the FFC Holder. (See
2. Remove the five screws and remove the Card Board.
• Screw : C.B.S. M3x10 (tightening torque: 5-7 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
1
5
3
Card Board
Figure 4-64. Removing the Card Board
Disassembly/Assembly
R260/R265/
Flowchart(p.64).
FFC Holder removal on page 76)
4
2
Removing Control Boards
Card Board disassembly
1. Disconnect the FFC from CN1 connector on the Card Board.
2. Remove the screw and remove the Ground Plate CB.
• Screw : C.B.S. M3x6 (tightening torque: 5-7 kgf.cm)
CN1
Figure 4-65. Card Board Disassembly
To match the FFC to the position of the Ferrite Core, twist and fold
the Head FFC as shown in the figure, then route it through the
Ferrite Core.
Head FFC
Figure 4-66. Routing the Head FFC (1)
Screw the Card Board in the order given in Fig.4-64.
Revision B
Ground Plate CB
82