Stacker Assy - Epson R260 - Stylus Photo Color Inkjet Printer Service Manual

Color inkjet printer
Hide thumbs Also See for R260 - Stylus Photo Color Inkjet Printer:
Table of Contents

Advertisement

EPSON Stylus Photo R260/R265/R270, R360/R380/R390
2.
Remove the screw that secures the P/S Assy, and remove the P/S Assy from
the Lower Housing.
Screw
: C.B.P M3x10 (tightening torque: 5-7 kgf.cm)
P/S Assy
Lower Housing
Figure 4-107. Removing the P/S Assy
When installing the P/S Assy, referring to Fig.4-106, put the
Ferrite Core into the cutout of the Lower Housing, and route the
connector cables through the six tabs.
Whenever the P/S Assy is replaced, the required adjustment must be
carried out.
See "Table 5-4. Adjustment Items (p.116)" in Chapter 5
Disassembly/Assembly
Ferrite core
Disassembly of the Printer Mechanism

4.5.6 Stacker Assy

Parts/Components need to be removed in advance
All exterior parts/ All control boards / Middle Housing / Printer Mechanism
Removal procedure
Take extra care to avoid injury from sharp metal edges. Before
starting, see the page given below to check the dangerous edges.
"4.1.8 Sharp Metal Edges (Danger!) (p.62)"
Refer to the Orientation Definition below for the directions in the
following procedures.
"4.1.6 Orientation Definition (p.61)"
1.
Lower the CDR Guide Lever to raise the Stacker.
2.
Disengage the hook, and remove the CDR Guide Lever.
Hook
Figure 4-108. Removing the CDR Guide Lever
3.
Lift the front side of the Stacker to push down its shaft side to lower the
Stacker.
CDR Guide Lever Spring
Figure 4-109. Removing the CDR Guide Lever Spring (1)
Revision B
CDR Guide Lever
Removal Direction
Push down
Stacker
CDR Shaft
95

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents